Water Heater Repair & Installation in Temple City, CA

When your water heater quits in Temple City, you don’t need a general plumber who “also does” water heaters — you need a specialist. Our shop is on Telegraph Road in Pico Rivera, a short drive south, and water heaters are the only thing we do. Our shop is in Pico Rivera — with same-day repair and replacement, upfront flat-rate pricing, and 24/7 availability.

From a leaking tank in a 1940s cottage off Temple City Boulevard to a tankless upgrade in one of the newer two-storey builds, we repair, replace, and install every major brand — and we handle the permit and inspection so you don’t have to.

Temple City was laid out in 1923 by Walter P. Temple on 400 acres carved from Rancho Santa Anita, and much of the housing that followed is modest 1940s and 50s ranch homes and cottages — many around a thousand square feet, and many still running water heaters installed decades ago. Replacement is when everything gets brought up to current code: seismic strapping, a drip pan and drain, proper venting, and an expansion tank where required. Older gas lines here also make earthquake shut-off valves an especially smart add-on.

We work across all of Temple City — from the streets around Temple City Boulevard and Las Tunas Drive out to the Rosemead and Arcadia edges — plus neighboring El Monte, San Gabriel and Rosemead. Every replacement includes the code items Temple City inspectors look for, and because local water is hard on tanks and tankless units alike, we’ll set you up with a maintenance schedule that extends the life of whichever system you choose.

Temple City sits on San Gabriel Valley groundwater, and it is hard. Golden State Water, which serves parts of the city, measured its neighbouring South San Gabriel system at 14 grains per gallon in 2025 — 240 mg/L as calcium carbonate — against the 10.5 grains that classifies water as very hard. That is tough on a tank water heater, where mineral sediment settles and insulates the burner until the unit overworks itself. Our Temple City repair calls usually start with a flush and an anode-rod check; on replacements we help you weigh a high-recovery tank against a tankless upgrade based on how hard your household is on hot water.

Temple City’s post-war cottages were built small and built early, which usually means a tight closet or garage install, an original gas line, and none of the drip pan, expansion tank or seismic strapping current code requires. The newer two-storey homes bring the opposite problem: longer runs and higher simultaneous demand, which is where tankless starts to pay.